User manual

18-16 SCPI Command Reference 2400 Series SourceMeter
®
User’s Manual
[:SOURce[1]]
:CURRent
[:LEVel]
:TRIGgered Set level when triggered:
✓
[:AMPLitude] <n> Specify current level.
1
0 ✓
[:AMPLitude]? Query current level. ✓
:SFACtor <n> Set current scaling factor
(-999.9999e+18 to +999.999e+18).
1.0 ✓
2
:STATe <b> Enable/disable current scaling factor. OFF ✓
2
:STATe? Query current scaling factor state.
:SFACtor? Query current scaling factor.
:STARt <n> Specify start level for I-sweep.
1
0 ✓
:STARt? Query start level for current sweep. ✓
:STOP <n> Specify stop level for I-sweep.
1
0 ✓
:STOP? Query stop level for current sweep. ✓
:STEP <n> Specify step value for I-sweep.
1
0
:STEP? Query step value for voltage sweep.
:SPAN <n> Specify span.
1
0 ✓
:SPAN? Query span. ✓
:CENTer <n> Specify center point.
1
0 ✓
:CENTer? Query center point. ✓
:VOLTage Path to configure V-Source: ✓
:MODE <n> Select V-Source mode (FIXed, SWEep, or
LIST).
FIXed ✓
:MODE? Query V-Source mode. ✓
:RANGe <n>|UP|DOWN| Select fixed V-Source range.
1
21 ✓✓
2
:AUTO <b> Enable or disable autoranging. ON ✓✓
2
:AUTO? Query state of autoranging. ✓
:RANGe? Query V-Source range setting. ✓
1. The parameter values for this command are provided with the detailed command reference information. Detailed infor-
mation on SCPI commands follows the last command summary table in this section.
2. If source V is active.
Table 18-7 (continued)
SOURce command summary
Command Description
Default
parameter SCPI
Source
memory