User manual
18-12 SCPI Command Reference 2400 Series SourceMeter
®
User’s Manual
[:SENSe[1]]
:CURRent[:DC] Path to configure current: ✓
:RANGe Configure measurement range: ✓
[:UPPer]
<n>|UP|DOWN
Select range by specifying the expected
current reading.
1
1.05e-4 ✓✓
4
[:UPPer]? Query range. ✓
:AUTO <b> Enable or disable auto range.
2
ON ✓✓
4
:AUTO? Query auto range. ✓
:ULIMit? Returns I compliance range. ✓
:LLIMit <n> Set auto ranging lower limit (-105e-6
to 105e-6).
1e-6 ✓
:LLIMit? Query auto ranging lower limit. ✓
:NPLCycles <n> Specify integration rate (in line cycles):
0.01 to 10.
3
1.0 ✓✓
4
:NPLCycles? Query integration rate. ✓
:PROTection Path to configure current compliance: ✓
[:LEVel] <n> Specify current limit for V-Source.
1
1.05e-4 ✓✓
4
[:LEVel]? Query current compliance limit. ✓
:TRIPped? In current compliance: 1 (yes), 0 (no). ✓
:RSYNchronize <b> Enable or disable measure and
compliance range synchronization.
OFF
:RSYNchronize? Query range synchronization.
:VOLTage[:DC] Path to configure volts:
✓
:RANGe Configure measurement range: ✓
[:UPPer]
<n>|UP|DOWN
Select range by specifying the expected
voltage reading.
1
21 ✓✓
5
[:UPPer]? Query range. ✓
:AUTO <b> Enable or disable auto range.
2
ON ✓✓
5
:AUTO? Query auto range. ✓
:ULIMit? Returns V compliance range. ✓
:LLIMit <n> Set auto range lower limit.
1
0.21 ✓
:LLIMit? Query auto range lower limit. ✓
:NPLCycles <n> Specify integration rate (in line cycles):
0.01 to 10.
3
1.0 ✓✓
5
:NPLCycles? Query integration rate. ✓
:PROTection Path to configure voltage compliance: ✓
[:LEVel] <n> Specify voltage limit for I-Source.
1
21 ✓✓
5
1. The parameter values for this command are provided with the detailed command reference information. Detailed information on SCPI
commands follows the last command summary table in this section.
2. For the Model 2430 Pulse Mode, auto range is invalid (error +831).
3. For the Model 2430 Pulse Mode, <n> = 0.004 to 0.100.
4. If source V is active.
5. If source I is active and auto ohms is disabled.
6.
Table 18-6 (continued)
SENSe command summary
Command Description
Default
parameter SCPI
Source
memory