User manual

11-10 Triggering 2400 Series SourceMeter
®
User’s Manual
Figure 11-2
Trigger configuration menu tree
Remote trigger operation
NOTE For the Model 2430, the following discussion on the remote triggering
pertains explicitly to the DC Mode of operation. The trigger model oper
-
ates a little different for the Pulse Mode. These differences are covered
in
“Pulse Mode triggering (Model 2430),” page 11-20.
NOTE For instruments with the contact check option, see Appendix F for details
on trigger operation.
Remote trigger model
The trigger model flowchart in Figure 11-3 summarizes remote trigger operation.
(The flowchart is essentially the same as the one for front panel operation shown
in Figure 11-1 except that remote commands to program the various trigger
parameters are shown on this diagram.) Operation is controlled by SCPI com-
CONFIG
TRIG
TRIG
LAYER
ARM
LAYER
HALT
IMMEDIATE
ARM IN COUNT
TRIGGER
IN
TRIGGER
OUT
DELAY COUNT
LINE EVENTS
TRIGGER
LINK
LINE
IMMEDIATE
GPIB TIMER MANUAL TLINK
ARM
OUT
EVENTS
↓STEST ↑STEST ↑↓STEST