User Manual
Index 2400 Series SourceMeter User’s Manual
Rear panel summary 1-7
Registers
Bit descriptions 15-11
Clearing 15-4
Condition 15-16
Event 15-16
Event enable 15-17
Measurement event 15-13
Operation event 15-12
Questionable event 15-15
Reading 15-6
Serial polling and SRQ 15-9
Service request enable 15-9
Standard event 15-11
Status byte 15-8
Relative 8-2
Front panel operation 8-2
Remote programming 8-3
Remote commands
Triggering 11-18
Remote operation 14-1
Auto zero 3-10
Compliance limit 3-8
Contact check function F-14
Data store 9-5
Digital output control 13-5
Guard selection 2-13
Limit testing 12-20
Measure only 3-21, 3-22
Operation enhancements 14-2
Pulse Mode configuration 5-11
Pulse Mode sweep 10-26
Selecting an interface 14-3
Sense selection 2-12
Source delay 3-14
Source-measure procedure 3-18
Sweep 10-19
Terminals selection 2-3
Triggering 11-10
V-source protection 3-12
Remote output configuration 13-12
Remote programming
Data store 9-5
Display 1-14
Filter 7-12
Math 8-7
Ohms 4-13
Range and digits 7-5
Relative 8-3
Speed 7-8
Sweeps 10-19
Response messages 14-12
RS-232 interface
Baud rate 14-14
Connections 14-15
Data bits and parity 14-14
Flow control (signal handshaking)
14-15
Operation 14-13
Sending and receiving data 14-13
Terminator 14-14
S
Safety symbols and terms 1-2
scaling factor 18-95
SCPI
Command reference 18-1
Command summary 17-2
Eliminating common errors B-8
SCPI commands see Command refer-
ence, Command summary, Com-
mon commands, and
Signal-oriented measurement
commands
Sensing 2-5
2-wire local 2-7
4-wire remote 2-7
Guard 2-9, 6-32
Ohms 4-6
Selection 2-12
Serial polling 15-9
Settings
Default 1-15
Factory default 1-16
Power-on configuration 1-15
Remote setups 1-18
Restoring 1-15
Saving 1-15
Short-form rules 14-10
Signal-oriented measurement commands
:CONFigure:<function> 17-2
:FETCh? 17-3
:MEASure[:<function>]? 17-5
:READ? 17-4
[:SENSe[1]]:DATA[:LATest]? 17-4
Single-element device binning 12-13
Sink operation 3-22
Source delay 3-13
Source I measure I and source V measure
V 6-22
Source memory sweep 10-6, 10-17,
10-22
Source-delay-measure cycle 6-7
Source-measure capabilities 3-4