User Manual
2400 Series SourceMeter
®
User’s Manual SCPI Command Reference 18-95
where: X = 2, 3 and 5 through 12
CALCulate2:CLIMits:PASS:SOURce2
CALCulate2:CLIMits:PASS:SMLocation
TRIGger:DELay (Model 2430 in DC Mode)
Contact check commands (Appendix F)
After saving the desired setups in consecutive memory locations
(unless branching, see CALC2:CLIM:PASS:SML), use the :POINts
command to specify how many sweep points to perform and the
:STARt command to specify where to start from.
POINts <NRf>
:SOURCe:MEMory:POINts <NRf> Specify number of sweep points to
execute
Parameters <NRf> = 1 to 100 Number of sweep points
Description This command is used to specify the number of points for the sweep.
For example, if you saved setups in memory locations 1 through 12
for a sweep, specify a 12-point sweep using this command.
STARt <NRf>
:SOURCe:MEMory:STARt <NRf> Select Source Memory Sweep start
location
Parameters <NRf> = 1 to 100 Specify memory location
Description This command is used to set the starting location of a Source Mem-
ory Sweep. For example, for setups saved in memory locations 98
through 5, specify a starting location of 98.
RECall <NRf>
:SOURCe:MEMory:RECall <NRf> Return to specified setup
Parameters <NRf> = 1 to 100 Specify memory location
Description This command is used to return the SourceMeter to the setup stored
at the specified memory location.
Set scaling factor
TRIGgered:SFACtor <n>
:SOURce[1]:CURRent[:LEVel]:TRIGgered:SFACtor <n> Set current scaling factor
:SOURce[1]:VOLTage[:LEVel]:TRIGgered:SFACtor <n> Set voltage scaling factor
Parameters <n> = -999.9999e+18 to 999.9999e+18 Scaling factor
Query :SFACtor? Query scaling factor