Manualshelf

User Manual

ManualsBrandsKEITHLEY ManualsLaboratory & Bench PSUsBench PSU (adjustable voltage) 0 - 20 V 0 - 1 A
21222324252627282930
2400 Series SourceMeter
®
User’s Manual Getting Started 1-7
SWEEP Start configured sweep.
left/right arrows Move through parameter values or selections within functions and operations.
DIGITS Change number of digits of display resolution.
SPEED Change measurement speed by selecting accuracy or specifying NPLC.
STORE Set buffer size and enable reading storage.
RECALL Display stored readings and timestamp.
CONFIG Press CONFIG and then appropriate key to configure function or operation.
MENU Access and configure Main Menu selections. When entering numeric data, use to
clear reading to minimum absolute value.
EXIT Cancels selection. Use to back out of menu structures.
ENTER Accepts selection.
RANGE keys:
∆ Moves to next higher range, increments digit, moves to next selection.
∇ Moves to next lower range, decrements digit, moves to previous selection.
AUTO Enables or disables measurement auto range.
Annunciators:
EDIT Instrument in edit mode.
ERR Questionable reading, invalid cal step.
REM Instrument in GPIB remote mode.
TALK Instrument addressed to talk over GPIB.
LSTN Instrument addressed to listen over GPIB.
SRQ Service request over GPIB.
REAR Rear input/output connectors selected.
REL Relative measure reading displayed.
FILT Digital filter enabled.
MATH Math function enabled.
4W Remote sensing enabled.
AUTO Autoranging enabled.
ARM Source-measure operations being performed.
TRIG External trigger source selected.
* Reading being stored.
Input/output connectors:
INPUT/OUTPUT HI and LOUse to source-measure volts, amps, and ohms.
4-WIRE SENSE HI and LOUse for 4-wire remote sensing.
Input/output controls:
ON/OFF Turns the source on or off.
FRONT/REAR Selects front or rear panel input/output connections.
Handle:
Pull out and rotate to desired position.
Rear panel summary
The rear panel of the Model 2400 SourceMeter is shown in Figure 1-2. (The Mod-
els 2410, 2420, 2425, 2430, and 2440 are similar.) The following abbreviated
information should be reviewed before operating the instrument.
NOTE Models 2420, 2425, 2430, and 2440 are not UL listed.