User Manual

10-22 Sweep Operation 2400 Series SourceMeter
®
User’s Manual
Source memory sweep commands
Table 10-7 summarizes remote commands used for custom sweep operation. See
Section 18, “Configure memory sweep,” for more details on these commands.
Table 10-7
Source memory sweep commands
Command Description
:SOURce:FUNCtion MEM
:SOURce:MEMory:POINts <n>
:SOURce:MEMory:STARt <n>
:SOURce:MEMory:RECall <n>
:SOURce:SAVE <n>
:SENSe:CURRent:RANGe:HOLDoff <b>
:SENSe:CURRent:RANGe:HOLDoff:DELay <NRf>
Select memory sweep mode.
Specify number of sweep points (n = points).
Select source memory start location (n = location).
Return to specified setup (n = memory location).
Save setup in memory (n = memory location).
Enable (ON), disable (OFF) current range holdoff.
Set holdoff delay in seconds.