User manual

3.1 How Do I Install?
Download the Keithley I/O Layer software from the Keithley Web site,
www.keithley.com/support . The software is a single compressed file and should be
downloaded to a temporary directory.
Run the downloaded file from the temporary directory.
Follow the instructions on the screen to install the software.
The software will install the following components (skipping any that are already
installed on your system)::
- NI IVI Compliance Package 4.5
- NI-VISA Runtime 5.2
- Keithley KESCPI IVI Instrument Driver SCPI-856C04
- Keithley I/O Layer KIOL-850C06
When the installation is complete, reboot your computer.
3.2 How Do I Upgrade?
If you have an earlier version of the Keithley I/O Layer software installed on your
computer:
1. Uninstall the earlier version of the Keithley I/O Layer by following the
listed steps below in the section “How Do I Uninstall?”
2. Install the new version of the Keithley I/O Layer by following the listed
steps above in the section “How Do Install?”
3.3 How Do I Uninstall?
If you have an earlier version of the Keithley I/O Layer software installed on your
computer, uninstall it by following the steps below before installing this version.
Using the Add/Remove Programs Wizard in Control Panel, uninstall the following
components:
- Keithley I/O Layer
- Keithley KESCPI IVI Instrument Driver
Reboot your computer.