User manual

Section
3: KI-Tool KI-Tool And KI-Link Software
User's Manual
3-8 2110-921-01 Rev. B / August 2013
The following figure shows the Device Settings window for an instrument without 2ND function
capabilities.
Figure 8: Device Settings window (instrument without 2ND function capabilities)
(1) Device List
Lists the instruments connected to the computer.
If you want to view or change an instrument's settings, click to highlight the instrument.
(2) Function
Lists the functions available for the instrument.
To configure a function:
1. Click the function you want to configure. After you select a function to configure, the labels for the
drop-down menus will change depending on which function you are configuring. See the following
table for information about the labels associated with each function.
2. Configure additional settings as necessary:
• (3) Range or Sensor (on page 3-9)
• (4) Resolution, Filter, Aperture, or Unit (on page 3-9)
• (5) 2ND function (if equipped) (on page 3-9)
• (6) Range or Unit (for 2ND function, if equipped) (on page 3-9)
• (7) NPLC, Bandwidth, Aperture, Sensor, and Transducer (on page 3-9)
3. Click Submit when you are finished with the configuration.
You must click Submit for the settings to take effect.