User manual

Section
3: KI-Tool KI-Tool And KI-Link Software
User's Manual
3-4 2110-921-01 Rev. B / August 2013
Y-Scale
The Y-Scale control allows you to adjust the size of the vertical axis division. Use the Up and Dn
(down) buttons to increase and decrease the span of the plots.
Offset
The Offset control allows you to apply an offset to each data point by adding or subtracting the value
entered. Enter the offset value and click the SET button.
Reading Speed
The Reading Speed control allows you to set the amount of time in milliseconds (ms) that the
instrument takes between readings. Select the Reading Speed from the drop-down menu.
X-Max
The X-Max control allows you to select the maximum number of readings that will display on the
completed graph. When you select an X-Max value, the KI-Tool software will show all the readings
until it reaches the X-Max number of readings. Then, it will show the last X-Max number of readings.
For example, if the instrument takes 1000 readings and X-Max is set to 100, the KI-Tool software will
only display 100 readings on the completed graph.
(5) Instrument Information
The Instrument Information display shows information about each instrument that is connected
including:
• Model number and connection type
• Selected function
• Line color
• The reading that the instrument is presently taking. This display changes each time the
instrument tales a reading. When the instrument is not taking readings, the display shows the last
reading taken.
The Instrument Information display only shows information about one instrument at a time. Select the
instrument to display from the Instrument List as shown in the following figure.