User manual

Model 2110
5½ Digit Multimeter Reference Manual Section 2:
General overview
2110-901-01 Rev. C/August 2013 2-17
Keys, menus, and selection Description
CONFIG (MENU)
Press CONFIG (MENU) to select the menu.
SET ADC
Select to configure autozero. Refer to Autozero (on page 3-38) for
details.
AUTO ZERO
Selects the autozero operation. Refer to Autozero (on page 3-38) for
details.
ON
Turns the function or operation on.
OFF
Turn the function off.
TRIG SYS
Access trigger system settings. Use ► and ◄ keys to display
additional selections.
READ HOLD
Set the sensitivity band of the reading hold function. If set, it will hold
the stable reading and trigger a beeping sound. Refer to Reading
hold (on page 3-35) for details.
STORE RDGS
Set number of readings to be stored.
DELAY
Access delay time settings for the trigger. Refer to Trigger delay (on
page 3-34) for details.
AUTO
Select auto delay time for the trigger. AUTO is the default. After
selecting AUTO, the menu structure will close.
MANUAL
Select manual delay time, and then select the delay time.
SAMPLE CNT
Select number of samples per trigger.
TRIG CNT
Select number of triggers.
SYSTEM
Access system settings. Use ► and ◄ keys to display additional
selections.
SCPI ERR
Check the error queue. Refer to Error codes (on page 6-3) for
information about error queue.
INIT MODE
Check the initial mode settings. Refer to Selecting the initial
operating mode (on page 2-23) for details.
DEFAULT SET
Recall the factory settings. Refer to Power-on settings (on page 1-6)
for details.
SAVE DATA
Save the current settings as the power-on state. Only the primary
and secondary measurement function, range, resolution, and math
functions are saved. Refer to Selecting the initial operating mode
(on page 2-23) for details.
SYSTEM VERSION
Display system version. Refer to Viewing system version (on page
2-24) for details.
INSTRUMENT INFO
Display instrument manufacturer and model number.
SERIAL
Display instrument serial number.
DISPLAY
Access display settings. Refer to Turning off measurement display
(on page 2-21) for details.
ON
Turn display on.
OFF
Turn display off.
BEEP
Access beeper settings. Refer to Turning the beeper off or on (on
page 2-22) for details.
ON
Turn beeper on.
OFF
Turn beeper off.
SELF TEST
Perform a self-test and display results. Refer to Running a self-test
(on page 6-2) for details.
LANGUAGE
Access remote command language settings. Refer to Selecting the
language (on page 2-23) for details.
DEFAULT
Set default language. The default language is: Model 2110 SCPI.
COMPATIBLE
Set to SCPI-compliant DMM language mode.