User manual

SCPI Conformance Information
2001-900-01 Rev. K / August 2010 I-19
:SENSe2
:TTL[1]
:DATA?
Path to read digital input port:
Query (read) the digital input port.
:SOURce
:TTL[1][:LEVel] <b>
:TTL[1][:LEVel]?
:TTL2[:LEVel] <b>
:TTL2[:LEVel]?
:TTL3[:LEVel] <b>
:TTL3[:LEVel]?
:TTL4[:LEVel] <b>
:TTL4[:LEVel]?
Set digital output line #1 true (1 or ON) or false (0 or OFF).
Query digital output line 1.
Set digital output line #2 true (1 or ON) or false (0 or OFF).
Query digital output line 2.
Set digital output line #3 true (1 or ON) or false (0 or OFF).
Query digital output line 3.
Set digital output line #4 true (1 or ON) or false (0 or OFF).
Query digital output line 4.
:STATus
:MEASurement
[EVENt]?
:ENABle <NRf>
:ENABle?
:PTRansition <NRf>
:PTRansition?
:NTRansition <NRf>
:NTRansition?
:CONDition?
:QUEue
:DISable <list>
:DISable?
:CLEar
Path to control measurement event registers:
Read the event register.
Program the enable register.
Read the enable register.
Program the positive transition register.
Read the positive transition register.
Program the negative transition register.
Read the negative transition register.
Read the condition register.
Path to access error queue:
Specify messages not to be placed in queue.
Read the disabled messages.
Clears all messages from Error Queue.
:SYSTem
:POSetup <name>
:POSetup?
:FRSWitch?
:AZERo
:TYPE <name>
:TYPE?
:STATe <b>
:STATe?
:AMEThod <name>
:AMEThod?
:LSYNc
:STATe <b>
:STATe?
:CLEar
Select power-on setup: RST, PRESet, SAV0-SAV9.
Query power-on setup.
Query INPUTS switch (0 = rear, 1 = front).
Path to set up auto-zero.
Select auto-zero mode: NORMal, SYNChronous.
Query auto-zero mode (0 or 1).
Enable (1 or ON) or disable (0 or OFF) auto-zero.
Query auto-zero (0 or 1).
Select reading acquisition method: BURSt, NORMal, ASTReam, SSTReam.
Query acquisition method.
Path to control line synchronization of measurements.
Enable (1 or ON) or disable (0 or OFF) line sync.
Query line sync (0 or 1).
Clears messages from the Error Queue.
Command Description