User manual

IEEE-488 Reference
2001-900-01 Rev. K / August 2010 4-137
Programming example 10 OUTPUT 716; “:curr:ac:dig:auto on; auto?”
20 ENTER 716; A$
30 PRINT A$
40 END
Line 10 Enables auto resolution for ACI, and then queries the state of auto resolution.
Line 20 Addresses the Model 2001 to talk.
Line 30 Displays the state of auto resolution (1).
4.19.11 :AVERage commands
:TCONtrol <name>
[:SENSe[1]]:CURRent:AC:AVERage:TCONtrol <name>Select filter type for ACI
[:SENSe[1]]:CURRent[:DC]:AVERage:TCONtrol <name>Select filter type for DCI
[:SENSe[1]]:VOLTage:AC:AVERage:TCONtrol <name>Select filter type for ACV
[:SENSe[1]]:VOLTage[:DC]:AVERage:TCONtrol <name>Select filter type for DCV
[:SENSe[1]]:RESistance:AVERage:TCONtrol <name>Select filter type for 2
[:SENSe[1]]:FRESistance:AVERage:TCONtrol <name>Select filter type for 4
[:SENSe[1]]:TEMPerature:AVERage:TCONtrol <name>Select filter type for TEMP
Parameters <name> = REPeat Select repeating filter
= MOVing Select moving filter
Formats :curr:ac:aver:tcon <name> :curr[:dc]:aver:tcon <name>
:volt:ac:aver:tcon <name>:volt[:dc]:aver:tcon <name>
:res:aver:tcon <name>:fres:aver:tcon <name>
:temp:aver:tcon <name>
Defaults Power-up Saved power-on setup
*RST REPeat (all functions)
:SYSTem:PRESet MOVing (all functions)
q~ÄäÉ=QJOR
Auto resolution; TEMP
Sensor
Resolution*
Digits Degrees
RTD
Thermocouples J, K, T, E
Thermocouples R, S, B
5H d
4H d
3H d
0.01°
0.1°
1°
* Auto resolution enabled.