Instructions

88
Table 34. Trigger command summary
Command Description
:INITiate
[:IMMediate]
:CONTinuous <b>
:CONTinuous?
:ABORt
:ARM[:SEQuence[1]]
[:LAYer[1]]
:IMMediate
:COUNt <n>
:COUNt?
:SOURce <name>
:SOURce?
:SIGNal
:TCONfigure
:DIRection <name>
:DIRection?
:ASYNchronous
:ILINe <NRf>
:ILINe?
:OLINe <NRf>
:OLINe?
:LAYer2
:IMMediate
:COUNt <n>
:COUNt?
:DELay <n>
:DELay?
:SOURce <name>
:SOURce?
:TIMer <n>
:TIMer?
:SIGNal
Subsystem command path:
Initiate one trigger cycle.
Enable (1 or ON) or disable (0 or
OFF) continuous initiation of
trigger system.
Query continuous initiation.
Reset trigger system.
Subsystem command path to con-
figure arm layers:
Path to program arm layer 1:
Loop around control source.
Program arm count (1 to
99999, or INF).
Query arm count.
Select control source: HOLD,
IMMediate, MANual, BUS,
TLINk, EXTernal.
Query control source.
Loop around control source.
Path to configure Triggers:
Enable (SOUR) or disable
(ACC) Bypass: SOURce,
ACCeptor.
Query direction.
Path to configure asynchro-
nous Trigger Link:
Select input line (1 to 6).
Query input line.
Select output line (1 to 6).
Query output line.
Path to program arm layer 2:
Loop around control source.
Program scan count (1 to
99999 or INF).
Query scan count.
Program delay (0 to
999999.999 sec).
Query delay.
Select control source: HOLD,
IMMediate, TIMer, MANual,
BUS, TLINk, EXTernal.
Query control source.
Set timer interval (0 to
999999.999 sec).
Query timer.
Loop around control source.