User manual

GPIB primary address
The GPIB primary address of the instrument must be the same as the primary address
you specify in the controller’s programming language. The default primary address of the
instrument is 16, but you can set the address to any value from 0 to 30 by using the following
step by step instructions.
1. Press SHIFT then GPIB.
2. Use the and keys to select ADDRess. Or, press ENTER. Once you have
pressed ENTER, the unit automatically displays the address selection.
3. Use the and keys to toggle from ADDRess to the numeric entry. Notice the
values are blinking.
4. Use the and keys to change the numeric entries to the desired address.
5. Press ENTER.
See Section Four — Remote Operation for more GPIB information.
Warm-up time
The Model 2000 is ready for use as soon as the power-up sequence has completed.
However, to achieve rated accuracy, allow the instrument to warm up for one hour. If the
instrument has been subjected to extreme temperatures, allow additional time for internal
temperatures to stabilize.
2000-900 (J - Aug 2010) BOOK.fm Page 16 Wednesday, October 12, 2011 12:29 PM