User manual

The Model 2000 can be configured to accept device-dependent commands of the Fluke
Models 8840A/8842A. The commands to control the Model 2000 with the 8840A/8842A lan
-
guage are provided in Table D-2.
Since the architecture of the Model 2000 differs from that of the 8840A/8842A, some com-
mands are different or cannot be used. Commands such as range, calibration, factory de-
faults, and self-test do not map one-for-one. Also note that the Model 2000 does not have
the speed characteristics of the Models 8840A/8842A. Other commands of the Model 2000
have been added to the 8840A/8842A command set, such as frequency, temperature, and
scanner channels. Refer to the appropriate manual for further details.
CAUTION The 8840A/8842A language is intended to be used only over the IEEE-488
bus. Using front panel controls in conjunction with this language may cause
erratic operation. In this case, results cannot be guaranteed.
Table D-2
Models 8840A/8842A device-dependent command summary
Mode Command Description
Function F1
F2
F3
F4
F5
F6
F7
F8
VDC (default)
VAC
2-wire kΩ
4-wire kΩ
mA DC
mA AC
Freq
Temp
Range
R0
R1
R2
R3
R4
R5
R6
R7
R8
VDC VAC kΩ* mA DC mA AC Freq
Auto on Auto on Auto on Auto on Auto on —
1V 1V 1kΩ 10mA 3A 1V
10V 10V 10kΩ 10mA 3A 10V
100V 100V 100kΩ 100mA 3A 100V
1000V 750V 1MΩ 1A 1A 750V
1000V 750V 10MΩ 3A 3A 750V
1000V 750V 100MΩ 3A 3A 750V
Auto off Auto off Auto off Auto off Auto off —
100mV 750V 100Ω 3A 3A 750V
*2-wire and 4-wire ohms
Reading rate S0
S1
S2
slow, 10 PLC
Medium, 1 PLC, 6H-digit resolution (default)
Fast, 0.1 PLC, 5H-digit resolution
2000-900 (J - Aug 2010) BOOK.fm Page 6 Wednesday, October 12, 2011 12:29 PM