User manual

SCPI command subsystems reference tables
Tables 5-2 through 5-11 summarize the commands for each SCPI sub-
system. The following list includes the SCPI subsystem commands and
the table number where each command is summarized.
CALCulate command summary (Table 5-2)
DISPlay command summary (Table 5-3)
FORMat command summary (Table 5-4)
ROUTe command summary (Table 5-5)
SENSe command summary (Table 5-6)
STATus command summary (Table 5-7)
SYSTem command summary (Table 5-8)
TRACe command summary (Table 5-9)
Trigger command summary (Table 5-10)
UNIT command summary (Table 5-11)
General notes:
• Brackets ([ ]) are used to denote optional character sets. These option-
al characters do not have to be included in the program message. Do
not use brackets in the program message.
• Angle brackets (< >) are used to indicate parameter type. Do not use
angle brackets in the program message.
• The Boolean parameter (<b>) is used to enable or disable an instru-
ment operation. 1 or ON enables the operation and 0 or OFF disables
the operation.
• Upper case characters indicate the short-form version for each com-
mand word.
• Default Parameter — Listed parameters are both the *RST and :SYS-
Tem:PRESet defaults, unless noted otherwise. Parameter notes are
located at the end of each table.
SCPI — A checkmark (√) indicates that the command and its parame-
ters are SCPI confirmed. An unmarked command indicates that it is
non-SCPI. SCPI confirmed commands that use one or more non-SCPI
parameters are explained by notes.
2000-900 (J - Aug 2010) BOOK.fm Page 7 Wednesday, October 12, 2011 12:29 PM