User Manual

Long Trig
Pressing and holding the key for 1 second will output a 127 followed by a 0 (100ms later).
Off Trig
(Hosted mode only)
Outputs a 127 followed by a 0 (100ms later) when the key is released.
Fast Trig Latch
(Hosted mode only)
Immediately outputs a 127 when the key is pressed. Does not go back to 0.
Dbl Trig Latch
(Hosted mode only)
Two quick presses of the key will output a 127. Does not go back to 0.
Long Trig Latch
(Hosted mode only)
Pressing and holding the key for 1 second will output a 127. Does not go back to 0.
Pedal
If an expression pedal is connected, this source will output the current value coming from the
pedal.
•
Range: 0-127
Init
(Standalone mode only)
Outputs a 127 whenever the current preset is loaded. Useful for initializing values whenever a
specific preset is loaded. Use the min and max options (or offset) in the modlines to send a specific
value.
Nav Yx10 & Key
Works in tandem with the Nav Pad. The Nav Pad must also be in Program Change mode or using
the Nav Y Decade source.
The Nav Pad’s current counter value is multiplied by 10 to get a “decade” —!e.g. 20s, 30s, 40s, etc.,
then the key number (this source is placed on) is added to the value when pressed.
Appendix 56