User Manual

4.2.2.1 Enable Buttons
Enables/Disables the modline.
4.2.2.2 Inits
Inits (short for “Initializations”) allow for initializing parameters/modlines when a preset is loaded.
Inits consist of two parts: a mode and a value.
Mode
The mode defines how the init behaves. More detailed
information on each of the available modes can be found in
the Inits section of the Appendix.
Value
Sets the value to output when the init is triggered. This value will be passed through the
modline it is placed on.
4.2.2.3 Data Sources
The Data Sources section of the modline selects what type of
sensor data (coming from the SoftStep) to use.
Source
Selects the type of sensor data to use —!e.g. key pressure, foot on, foot off. For a complete list
of all available sources (and what they do), see the Sources section of the Appendix.
Raw
(Hosted mode only)
A live display of sensor data coming from the selected source.
4.2.2.4 Data Modifiers
The Data Modifiers section allows the values coming from the selected source to be processed in
various ways —!add a multiplier or offset, set min and max values, add some smoothing, and more.
1
0off
Va lu eMode
Pressure Live
37
Source Raw
37 1.27
-24.
23
Linear
0 127 333 999
x
+ =
GainRaw Offset Result Tab le Min Max Smooth Delay Va l u e
23
Advanced Editor 36