User Manual

X/Y
The X/Y option allows a key to output X (left-right) and Y (down-up) location data as CC messages.
X-axis and Y-axis data may be used separately or simultaneously.
The following options are available when X/Y is selected:
X CC #
This box sets the CC number to output the X-axis location data on.
•
Range: 0-127
•
Enter -1 (negative one) to disable the X-axis CC.
Y CC #
This box sets the CC number to output the Y-axis location data on.
•
Range: 0-127
•
Enter -1 (negative one) to disable the Y-axis CC.
Latch
The Latch checkbox enables and disables latch mode on the X and Y CCs. When checked, the
X and Y CCs will stay where they were (“latch”) when the key is released. When unchecked, the
X and Y CCs will return to center (63) when the key is released.
Y Inc
Short for Y Increment, this option will turn a key into a virtual slider. Putting pressure on the top
portion of the key will make the value increment — putting pressure on the bottom portion of the
key will make the value decrement.
The following options are available when Y Inc is selected:
CC #
Sets the CC number to output the Y Increment value on.
Program
The Program option allows a key to output a program change and/or bank select message when
pressed.
The following options are available when Program is selected:
Program #
Sets the program change number to output when this key is pressed.
•
Enter -1 (negative one) to turn off the program change message.
Bank #
Sets the bank select number to output when this key is pressed.
Basic Editor 28