User's Manual

min / max - These allow you to constrain the data values between a minimum and a
maximum number. If the min is set to 10 and the max is set to 15, then the output cannot
be less than 10 or more than 15.
The example in the image above shows the Velocity MIDI parameter. The source for voice A
is set to +Velocity so the harder you initially press on the key, the greater the velocity will
be. Voice B is set to -Velocity so the harder you initially press on the key, the lower the
velocity will be. The gain is set to 1 and the offset is set to 0 so at this point the outputting
values have not yet been altered. A linear curve is used so again the value is not altered.
With Min set to 0 and Max set to 127, the full range is allowed so the values are able to
output as they are. This is a simple way to set up 2 voices with opposite velocities.
If you experience any problems or have questions regarding the 12 Step install process
submit a support ticket outlining the problems you're experiencing at
www.keithmcmillen.com/support. The more detailed you are in describing your problem
(information about your computer, the software you're running, the circumstances around
the issue), the more easily we will be able to help you.
23