User's Manual

User Manuel
No：JLDK.18.01.29
RF358C (39WIRELESS) Page 2 of 2

 2/2

the pairing is successful, LED will stop flashing.
7. LED:Inunlockedstate,theremotecancontrolactuatorsnormallyandLEDwillonwhenyou
pressanybutton.Inlockedstate,LEDwillflashwhenyoupressanybuttonwhichindicates
theremoteislocked.
8. Childlock
PressandholdtheHEADUP&HEADDOWNandtheLEDwillflashby1Hzatthesametime.
After5timesflash,theLEDwillturnoffandtheremotewillenterintolockedmode.
PresstheFOOTUP&FOOTDOWN,theLEDwillflash
by1Hz.After5timesflash,theLEDwill
turnoffandtheremotewillenterintonormalmode.

Fcc warning
ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,
pursuanttoPart15oftheFCCRules.Theselimitsaredesignedtoprovidereasonableprotection
againstharmfulinterferenceinaresidentialinstallation.Thisequipmentgenerates,usesandcan
radiateradiofrequencyenergy
and,ifnotinstalledandusedinaccordancewiththeinstructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interferencetoradioortelevisionreception,whichcanbedeterminedbyturning
theequipment
off and on, the user is encouraged to try to correct the interference by one of the following
measures:
- Reorientorrelocatethereceivingantenna.
- Increasetheseparationbetweentheequipmentandreceiver.
- Connecttheequipmentintoanoutletonacircuitdifferentfromthatto
whichthe
receiverisconnected.
- Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.