Instruction Manual

Tianjin Keepsens Information Technology Co., Ltd.
5
Figure 2-3 Bracket Drilling Position
Figure 2-4 Drilling Position of Chamfering Bit
5) The Φ4.5 drill is used to drill holes at the location hole marked by Step 3), as shown in Figure
2-5.
Note: Don't directly drill a hole by the mounting bracket.
Figure 2-5 Drilling of Mounting Bracket
6) Put the mounting bracket back to the position as per Step 3), align 2 holes of the bracket to the
borehole in Step 5), insert the screw into the hole of mounting bracket from the container outside,
harness the gasket and spring washer onto the screw from the container inside successively, and
use the nut to fix the screw to complete the fixation of mounting bracket. All boreholes on the
container wall shall be sealed with XD-6120 silica gel.
Figure 2-6a Fixation of Mounting Bracket
Figure 2-6b Fixation of Mounting Bracket