Instruction Manual

Tianjin Keepsens Information Technology Co., Ltd.
4
mounting bracket to the container wall. The distance between the upper side of the host and the
upper edge of the container is about 15cm, as shown in figure 2-2b, the solar panel and equipment
marks face the outside of the container, and the equipment mark is under the solar panel.
Note: Ensure that the surface of the host is clean and dry, and the scouring pad or towel can be
used for cleaning when necessary.
Note: The host cannot be placed on the welding cracks or rivets.
Figure 2-2a Host Installation Site
Figure 2-2b Host Installation Site
3) Take down the host, mark the position of 4 location holes of the mounting bracket on the
container wall (2 pieces for each bracket) and take down the mounting bracket.
4) Drill holes with the chamfering bit (diameter: 20mm) 1~2cm below the upper mounting bracket,
as shown in Figure 2-3.
Warning: In case of spark or inevitable overheating in the process of drilling, the installation shall
be stopped immediately.