User's Manual

⚫ The electric quantity of the robot is lower than the value of recharging

electric quantity set by the user.

⚫ The robot is outside the working period, and its electric quantity is

lower than 100%.

Please refer to the “Charging Setup” in the setup part of this Manual for the

setup of triggering condition of autonomous recharging.

3. The user triggers the charging of robot manually

The user can trigger and control the automatic recharging of the robot by

operating the PEANUT APP. The specific operation steps are as follows:

① Enter the user setup page and find [Charging Setup], or enter the super

setup page and find [Power Management].

② Click the [Charge Immediately] button, and the robot will set out

immediately to look for the charging pile for charging.

③ After the robot arrives at the location of charging pile, it starts to match

and connect the charging pile autonomously.

④ Charging can be started after the robot has matched and connected the

charging pile.

The user can also push the robot manually to the charging pile for charging,

and the specific operations are as follows:

① Enter the user setup page and find [Charging Setup]; or enter the super

setup page and find [Power Management].

② Click [Push to Charging Pile Manually] below [Charge Immediately], and

the page will skip to the manual charging page.