Product Manual

3.3 Assembly 3.3

Fitting the Squaring Arm

1. Remove the Squaring Adjuster Block from the right hand Leg by releasing the

middle screw only (take note how this is fixed in place as it will replaced after the

Squaring Arm has been fitted)

2. Slide the Squaring Arm in through the gap in the Main Body and screw the two

hexagon bolts and washers in place loosely (3 or 4 turns will do).

3. Fit the screws with spacers through the Squaring Arm into the legs, put the screws

all the way in but do not tighten at this stage.

4. Move the cutting head to its lowest position.

5. Refit the Squaring Adjuster block by firstly sliding the steel bar into the opening in

the Squaring Arm, then align the heads of the two screws in the Leg to fit the top and

bottom holes in the adjuster block. The screws fixing the Squaring Arm to the

machine should still be loose and allow it some movement to help alignment. Insert

and tighten the screw in the middle hole.