Item Brochure

Excalibur 5000
The world’s finest cutting machines
www.keencut.com
[phone] [e-mail]
Scan for further information
https://www.keencut.com/product/excalibur-5000/
Consistent perfect cuts every time
The Excalibur 5000 cuts all materials down the same line, so there is no need to
alter production stops for different materials. After a simple initial set-up, the
cutter maintains permanent 90-degree accuracy. A one-piece, horizontal
squaring arm ensures positioning and rigidity either side of the cut line and
accuracy is assured with a clear sightline strip acting as your guide to precise
alignment. Materials are then held firmly by a unique pressure-sensitive clamp,
which is designed to protect delicate surfaces from damage.
Saves time and money
By reducing set-up and cutting time the Excalibur 5000 increases your
productivity. All tools are permanently mounted for instant selection, allowing
you to switch between cutting mount board, hardboard, glass and acrylic in
seconds. All four blades cut along the same line, so you only prepare one stop
setting and one measurement. Everything has been designed to save you time,
reduce costly mistakes and reduce waste.
Multiple tools
The two heads house four cutting tools. The lower multi-tool head has a unique
ratchet system that provides incremental cutting of thicker materials. The upper
twin wheel cutter cuts 3mm (1/8″) MDF in a single pass producing a clean edge.
A balance weight parks the twin wheel head at the top when not in use and
cutting is achieved without noise, dust or debris.