Product Manual

3.1
Assembly
The rst stages of assembly are carried out with the machine laying on the oor.
NOTE: When lifting the main body from the box do not lift using the black handles on the cutters.
DO NOT untie balance weight cord at this stage.
Remove the main body from the box and lay it on the oor, remove the packaging from the bottom
end.
1. Slacken the bottom two screws on each leg using the 5mm hexagon wrench and extend the
telescopic parts to the desired length. (These can be re-adjusted later before xing the
machine to the wall). Tighten screws rmly to clamp in position.
2. Swing both legs outwards as far as they will go.
Adjusting the legs
❶
❶
❷❷