Product Manual

Evolution3 SmartFold User Guide
The world’s finest cutting machines
www.keencut.com
[phone]
[phone]
[e-mail] (UK HQ)
[e-mail] (US sales)
Scan the QR code or
click here to view this document online >
Page 28 of 48
5.2 Engage the plastic cutting strip
Before using the Fabric tool head, you must engage the plastic cutting strip to ensure a clean cut.
See how to engage the plastic cutting strip in this video >
Raise the cutter bar.
Press and hold down the highlighted button on the right side of
the unit. Push the end of the cutter bar away from you.
There are four cutting positions on the strip numbered 1 to
4, align the edge of the aluminium end
block approximately so the number 1 on the label is seen, release
the button and move the top section backwards and forwards
slowly until the button clicks into place. Repeat these steps on
the other side of the unit.
Once track 1 has worn move onto tracks 2, 3 and 4 as required.
If all tracks are worn the strip can be turned over or see how to
change the plastic cutting strip >