Product Manual

Evolution3 SmartFold User Guide
The world’s finest cutting machines
www.keencut.com
[phone]
[phone]
[e-mail] (UK HQ)
[e-mail] (US sales)
Scan the QR code or
click here to view this document online >
Page 13 of 48
3. Make your first cut
3.1 Align and clamp the material
See how to align and clamp the material in this video >
Pull the lever to raise the cutter bar, place the material for
cutting approximately in position under the cutter bar.
Push the lever to lower the cutter bar so it is only 1-2mm (1⁄16”)
above the surface of the material, the closer to the material it is
the less lining up error you will get when viewing the cut marks.
NOTE: If you find the cutter bar is touching or too low in the
middle the cutter bar sag will need adjusting
See how to remove cutter bar sag >