Product Manual

Fitting and use of the HSGM HOT KNIFE

3 To fit the Hot Knife, simply insert it into the holder ensuring the nose of the Hot Knife is seated fully into

its r

ecess.

Tighten knob

A and check the Hot Knife is fully gripped in position, the blade should cut about 2-3mm

(1/16” to 1/8”) away from the edge of the slideway.

4 Depress the Hot Knife and the trigger should switch the heat on prior to it coming into contact with

the fabric.

The trigger can be adjusted to alter the position the heat is switched on by loosening screw C and

sliding the Trigger Block

E left or right.

5 Once the blade has reached the correct temperature press down to bring the blade in contact with the

fabric and slide the cutting head to the right to seal and cut it.

A heatproof protective surface F must be placed on the base of the machine

under the fabric.