Product Manual

Operation

4.1 How to use the brakes

The Lifter is equipped with 2 brakes.

1. To engage the brake, press the “ON” tab down with your foot until it locks into

place.

2. To release the brake, press the “OFF” tab down with your foot.

4.2 Loading the roll onto the tray

1. Ensure the load tray is at its lowest position.

2. Make sure the brakes are applied.

3. Lay out the securing straps across the load tray, and extended onto the oor.

4. Position the media over the straps, and up to the edge of the load tray.

5. Move towards the back of the On-A-Roll Lifter®.

6. Take the ends of the

straps and pull them

towards you until the

roll media falls in place on

the load tray. Make sure the

media is properly centered

in the media tray.

7. If roll is too heavy to lift,

carefully use a fork lift to

place the roll onto the

media tray.

8. Secure the straps.

Lock shown on the

Caster Wheel in the

unlock position.

Lock shown on the

Caster Wheel in the

lock position.