Product Manual
Installation Guide
7
3.3 Installing the Lifter Tray
1. Place media tray on top of the frame lining up the 12 holes on the tray with the
holes on the fork support frame.
2. Place the screw through the hole on the tray. Underneath the tray and fork support
frame, place the split washer, washer and nut on it. Lightly tighten and repeat with
remaining holes.
3. Tighten all 12 screws using a Phillips Head Screwdriver and a 10mm wrench;
securely attaching the Lifter Tray to the On-A-Roll Lifter®.
THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY
INFORMATION THAT MAY NOT BE REPRODUCED OR DIVULGED, IN WHOLE OR
IN PART, WITHOUT WRITTEN AUTHORIZATION FROM FOSTER KEENCUT.
THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY
INFORMATION THAT MAY NOT BE REPRODUCED OR DIVULGED, IN WHOLE OR
IN PART, WITHOUT WRITTEN AUTHORIZATION FROM FOSTER KEENCUT.
Foster Keencut