Product Manual
6
Installation Guide
3.2 Installing the Ergonomic Pull Bar
1. Using the 5mm Allen Key, loosen the 4 bolts enough to allow the push bar
entry through the openings.
2. Insert both sides of the push bar with the straight ends towards the back and the
curved ends facing the front of the lifter.
3. Slide a rubber sleeve onto both sides on one end.
4. Connect the two sides in the center with one side overlapping the second side so
that they t together and centered.
5. Tighten the 4 bolts.
6. Slide each rubber sleeve over the gap.
1
2
3