Product Manual

9
Operation
4.3 Loading the roll onto the tray
1. Ensure the load tray is at its lowest position.
2. Make sure the brakes are applied.
3. Attach the roll ramp and the rear roll wedge to the desired position.
4. Lay out the securing straps across over the roll wedge, load tray and roll ramp,
and extend onto the oor.
5. Position the media roll over the straps, and up to the edge of the load tray.
6. Move towards the back of the On-A-Roll Lifter®.
7. Take the ends of the straps and pull them towards you until the media roll rests on
the rear roll wedge and in place on the load tray. Make sure the media is properly
centered in the media tray.
8. Secure the straps.
9. Remove the roll ramp and store it on the back of the lifter. Adjust the front roll
wedge to help hold the roll in place during transport.