Product Manual

Cutting Unequal Margins
■ UNEQUAL MARGINS - Cuting a Mat with UNEQUAL MARGINS, for example 3,3,3 & 4.
Mark the back of the Mat with margin widths on each of the four edges as shown.
Place the Mat under the Cutterbar.
 Set the Matguide Limit Stop (blue) to the size shown on the left hand edge of the Mat (to 3 in this case).
Set the Start of Cut Limit Stop (green) to the size shown on the top of the Mat (to 3 in this case).
Set the End of Cut Limit Stop (red) to the size shown on the bottom of the Mat (to 4 in this case).
Make the first cut - turn the mat 90 degrees counter-clock wise .
 Set red stop to 3
Make a second cut - Turn the mat 90 degrees counter-clock wise.
 Set green stop to 4
Make a third cut - Turn the mat 90 degrees counter-clock wise.
 Set green stop to 3
Set blue stop to 4
Make the last cut.
Refer to ‘Additional Matguide fittings’ when cutting large quantities of Unequal Margin mats.
English
  
KEY:

Cutterbar  End of Cut Limit Stop

Matguide Limit Stop
➠
1st Cut
NOTE: Continue changing the Limit Stops before
making each cut.
➠
3rd Cut
➠
2nd Cut
➠
4th Cut
6.1 Cutting techinques 6.1
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920