Product Manual

3.4 Assembly 3.4

Fitting the Pull Bar (210 only)

The SteelTraK 165 offers a fast, accurate and robust way to cut boards measuring up to

165cm (65”). The SteeltraK 210 utilises a ‘Pull Bar System’ to increase the cutting

length to 210cm (82”) without compromising the straightforward way the SteelTraK cuts

medium size boards. The ‘Pull Bar’ is only used when cutting between 165cm and

210cm and is automatically stowed out of the way when not in use by virtue of its

integral spring balance

At any stage of the assembly before standing the machine up, fit the Pull Bar using a

6mm Allen key:

1. Remove the Screw and Stub Shaft from the end of the Pull Bar.

2. Insert the end of the Pull Bar in the bracket as shown ensuring the handle at the

other end is facing in the correct direction.

3. Insert the Screw and Stub Shaft and tighten.