Product Manual

6.1 Operation 6.1
Using the clamp
The Clamping system enables the operator to control the grip pressure by means of an
integral friction brake that maintains the clamping force at the pressure applied by the
operating lever. Soft materials can be held firmly without sustaining damage and solid
materials held rigidly without movement. By following the guidelines below it will help
you to get the most from the machine:
USE CLAMPING INSTRUCTIONS
Soft materials such as Use light to medium pressure. The underside of the clamp
Foamcor
e boar
ds,
grips an ar
ea nearly 4cm (1
1
/2”) wide with a non-marking
Lightweight card, etc. sponge rubber reasonable force can be applied. If in doubt
clamp a sample first
with the good surface facing outwards.
Harder materials such as PVC Use medium to heavy pressure.
foam board, MDF or Composite
boards such as Dibond.
Cropping to trim lines,
Place material in appr
oximate position under clamp, apply light
pencil marks, etc. clamp pressure to allow the material to be repositioned. Align
(See drawing) the trim marks with the edge of the Sight-line strip and clamp.