Product Manual

5.1 Maintenance 5.1
CLEANING AND LUBRICATION
It is good practice to keep a dust sheet over the cutter if it is not to be used for
extended periods. In any event regularly clean it with a dry cloth or to remove any
stubborn stains use a cloth dampened with a little water/detergent.
Should the cutting head slideway require lubrication use a silicon spray or silicon
impregnated sponge.
CUTTING HEAD BEARINGS
The bearings that control the sliding motion of the cutting head are manufactured from a
high grade polymer and under normal use will last for an extremely long time. As they
settle into position you may find a slight amount of side play, this can be removed by
tightening the two adjustment screws:
Place the long end of the 2mm Allen key provided into any of the two screws
J
and
very gradually tighten it with one hand whilst moving the cutting head up and down the
cutter bar with the other. Once you feel the sliding motion start to tighten undo the
screw the smallest amount so the cutting head just slides easily.
Repeat this on the other screw, further finer adjustment on each screw may be needed
to achieve an easy sliding movement with zero side play.
■ Please note! Do not use oil or solvents to lubricate or clean the cutter, because
the plastic components and bearings will be damaged.
J
KEENCUT Limited E-mail: [e-mail]
KEENCUT Limited accepts no liability if the pr
oduct is not assembled and used in the corr
ect way
.