PP003 V1.
Contents Hardware Installation and Introduction .............................................. 1 Software Installation............................................................................. 3 Add pet feeder via QR code mode .............................................. 3 Add pet feeder via AP mode ......................................................... 8 Add pet feeder via Auto Scan mode .......................................... 10 Feeding ..........................................................
Hardware Installation and Introduction 1. Open the battery compartment at the bottom of the feeder, insert the Micro USB power cord into the connector at the bottom; and extend the power cord out along the designed wire guide. You can also insert 3 pieces of D cell batteries which will enable the feeder to work automatically according to your scheduled feeding plan even without an external power supply. Turn on the power switch. Power switch 2. Rotate the knob on the top cover.
Note: Due to the wide variety of pet foods on the market, it cannot be guaranteed 100% that the mechanical structure of the feeder will fit all types of pet food. We recommend using only dry food within 5–15mm in size. Wet food and damp food are strictly prohibited from being placed in the feeder. 3. For your pet's health, please wash the feeding bucket and feeding tray regularly. The feeder body should not be filled with water. Please wipe it with a wring-able wet cloth. 4.
. You can push the camera to turn down to observe the feeding tray. The feeder supports up to 4 levels of angle adjustment. It supports Micro-SD card recording, and the SD card slot is visible when the camera is turned to the bottom. SD card slot Software Installation Add pet feeder via QR code mode 1. Search the App Store or scan the QR code below to download and install Pet Zero. Pet Zero Download Website 1 Download Website 2 2.
the account, please choose the correct country or area. 3. When you login, the App will ask you to access certain permissions. These permissions are very important for the App so please allow them. Click Add Device or + to add a new pet feeder. Choose the Add Manually tab and select Smart Pet Feeder. 4. After turning the feeder on, wait for about 1 minute for it to boot up.
second. If yes, then click next step to go to the next step. If not, please long press the Wi-Fi Settings button for 5 seconds until you hear a beep. After a few seconds, the feeder's indicator LED will flash RED rapidly. Long press Flashing RED rapidly Wi-Fi Indicator status: Flashing rapidly in RED Flashing slowly in RED Always on in RED Always on in GREEN Feeder is waiting for Wi-Fi network configuration; it is in QR code mode and auto scan mode.
