User manual

Using the charging station
14 / 20
3.5 Programming RFID user cards (optional)
The authorization by an RFID master card is necessary for the programming. The
programming mode can be activated and deactivated with the RFID master card
which is programmed during commissioning of the charging station.
► Activating programming mode:
Hold the RFID master card in front of the RFID sensor and wait for the signal tone.
► Programming RFID user cards:
Hold the new RFID user card in front of the RFID sensor within 5 seconds and wait for the
signal tone.
► End programming mode:
To confirm, hold the RFID master card in front of the RFID sensor again within 5 seconds
and wait for the signal tone.
The RFID user card is now programmed.
Deleting RFID user cards:
The deletion of all stored RFID user cards is only possible by opening the device (see “Installation
manual”.