User Manual

8
KDS Gemini 88
Auto Stop
Proportional
Continuous
Remote
Run
ml/min
µl/min
ml/hr
µl/hr
mm
Syringe 1
Syringe 2
The user interface consists of a display area and a keypad. The display consists of a 5 digit
LED display and 14 LED indicators. The display will be showing either the default display or
an informational message. The two syringes are referred to as Syringe 1 and Syringe 2.
Syringe 1 is located towards the front and Syringe 2 is located towards the rear. Rate 1
refers to the set flow rate of Syringe 1 and Rate 2 refers to Syringe 2.
By default, the display will be showing Rate 1. Informational messages are shown when the
user queries another data value by pressing the corresponding key, or when the pump is
alerting the user to a problem. Such problems are a value out of range (oor) or the pump
stalling (StALL).
The 14 LED indicators are divided into three sections: Pump mode and state, syringe direc-
tions, and units of value being displayed. See Figure 2. The LED indicators are as follows:
Pumping Mode and State LEDs Meaning
Auto Stop Pump is in Auto Stop mode
Proportional Pump is in Proportional mode
Continuous Pump is in Continuous mode
Remote Pump Chain communication
Run At least one motor is operating
Syringe Directions LEDs
Comprising of 4 indicators, these LED’s indicate the direction of the syringes when
illuminated. When
blinking, indicates the corresponding motor is stalled, or data
pertaining to that syringe is being entered.
Unit LEDs Meaning
ml/min milliliters per minute
µl/min microliters per minute
ml/hr milliliters per hour
µl/hr microliters per hour
mm millimeters
Figure 2. User Interface
User Interface:
DESCRIPTION OF KEYS