Manual

15
KDS Allegro Peristaltic Pump System User’s Manual
phone [phone] fax [phone]
e-mail [e-mail] web www.kdscientific.com
KD Scientific Allegro Peristaltic Pump System User’s Manual
Publication 5613-004-REV-A
Product Overview
TUBE LOADING
1. Turn off the Allegro Peristaltic Pump controller.
CAUTION: Stop the drive when
changing the tubing or its position in the
r
otor mechanism (the rotor is partially
exposed when the LOADING LEVER is
in the open position).
!
2. Rotate the lever to the left to open the pump head.
3. Load the correct size tubing between the retainers.
Please use Masterflex L/S® tubing only. Center the
tubing between the retainers as shown in Figure 1.
4. Rotate the lever to the right to close as shown in
Figure 2.
Figure 1: Open and Load Pump Head
Figure 2: Close Pump Head
Note: The Allegro I single channel head is shown in Figure
1 & 2. The above instructions also apply to the dual
channel head used on the Allegro II model and the two
stacked single channel heads used in the Allegro III model.