Manual

14
KDS Allegro Peristaltic Pump System User’s Manual
phone [phone] fax [phone]
e-mail [e-mail] web www.kdscientific.com
KD Scientific Allegro Peristaltic Pump System User’s Manual
Publication 5613-004-REV-A
Product Overview
OPERATING INSTRUCTIONS
POWER CONNECTIONS
1. Plug the power supply into the pump.
2. Connect to a properly rated line cord. The Allegro
Peristaltic Pump power supply has a DC power
input connector on the rear of the unit. The operating
range for the Allegro Peristaltic Pump System series is
100 – 240 VAC, 50-60 Hz.
3. Turn on the main power switch.
!
CAUTION: Do not connect to
firewire ports on a computer.
Damage may occur to the
pump or computer.
Run / Fault LED
U
ser Interface
Touchscreen
Protective Antiglare
Close up view of the Allegro Peristaltic Pump rear connections
(connections vary depending on model type)
Foot Switch
I/O Connector
USB Serial Input
(Type B)
RS-485 Connection
(Pump to Pump)
Main Switch
DC Power Input
*Power Source -
When powering a pump
in a chain through an RS-
485 cable, toggle switch
to RS-485. Only one
pump can be powered
from the master through
the RS-485.
Allegro Peristaltic Pump shown above