User Manual
17
Setting the Auto Drain Mode
For slim mat type models (EQM5 ** - * S), please connect the kit
to the boiler rst.
There is a risk of burns, so suciently cool the boiler and mat before draining.
ý If you use the water for a long time without replacing the water, minerals and other components in
the water may solidify and cause foreign substances like incrustation.
ý Even after the automatic water drainage, there may be remaining wat in the mat depending on the
usage environment. Use the enclosed air pump and residual water removal kit to remove the
remaining water.
ة After turning o the boiler, suciently cool the water in the boiler and the mat.
ت If the water is cool enough, place the boiler and the mat on the oor and prepare a drip tray
(about 1.8L) and an Auto drain kit.
ýIf the mat is above the Auto drain kit, water may overow.
ث Remove the boiler and mats by pressing the easy connector on the back of the
boiler connector.
ý Be careful because some water drops may fall between the connectors.
جOpen the water inlet lid of the boiler and check if the water is full.
If the water is full, close the cap tightly; otherwise ll the water.
ýAutomatic drainage function is to automatically discharge the water inside
the boiler and mattress pad.
Normal operation is possible when the water in the boiler is full and the
water inlet lid is properly closed.
حTurn on the boiler again and touch the drain button for about 2 seconds.
خFollow the voice guidance to connect the Auto drain kit between the
boiler and the mat connector, and then press the drain button again.
ý Please connect the Auto drain kit following the voice guidance
ý If the connection order is reversed, it may cause leakage.
دAfter the automatic drainage mode, please tilt the boiler as shown in the gure to remove the remaining
water.
ذ Press the protruding part of the water-inlet/outlet connector at the rear of boiler as shown to
remove the residue.