User's Manual

© 2014 KCodes Corporation. All rights reserved. 6 Series v2 User’s Manual V1.0
network through the network cable. Otherwise it will always connect to the network through wireless
module.
Once 601n v2/604n v2 connects to the network, either by network cable or by wireless module, all
operations to use USB device server are exactly the same.
3.3. Assigning an IP Address to the Server
3.3.1. Preliminary
 If you have a DHCP server on your network, your Server will receive an IP address
automatically. The IP address will then appear on the Control Center or on the page of
configuration report that you printed earlier. If your DHCP server does not give an IP address
to the Server, the Server will use the automatic private IP addressing IP: 169.254.0.0. ~
169.254.255.255
 If you are not working in a DHCP network, you need to manually set the Server’s IP address.
3.3.2. IP Address
 Unless you are assigning an IP address using DHCP, you must obtain an unused IP address
from your network administrator.
3.3.3. Methods for Setting the IP Address
You can set the IP address of your Server using one of the following methods, depending on your network
operating environment:
 Automatic IP Address Assignment
 Manual IP Address Assignment
3.3.4. Server Names and Server Name Rules
The default server name of the Server is “KC601” (for 601) or “KC604” (for 604) or “KC601n” (for 601n) or
“KC604n” (for 604n). If you put two or more Servers in your local area network, to avoid using the same
server names you have to change the server names by using the Control Center or the Server’s web pages.
If your server name is longer than 15 characters, the Server uses only the first 15 characters.
3.3.5. Setting the IP Address Using DHCP
Follow the instructions below to get an IP address using DHCP: