User's Manual

11
10. Click Submit to save your settings. And the server will reboot.
11. You have now finished the procedure of setting the wireless parameters.
After properly configuring the wireless parameters, you can remove the network
cable and reboot the KCodes 601n/604n. KCodes 601n/604n will then connect to
your wireless network. KCodes 601n/604n will detect if a network cable is
plugged-in or not. If a network cable is plugged-in, KCodes 601n/604n will always
connect to the network through the network cable. Otherwise it will always connect
to the network through wireless module. Once KCodes 601n/604n connects to the
network, either by network cable or by wireless module, all operations to use USB
device server are exactly the same.
3.3 Assigning an IP Address to the Server
3.3.1 Preliminary
 If you have a DHCP server on your network, your Server will receive an IP
address automatically. The IP address will then appear on the Control Center
or on the page of configuration report that you printed earlier. If your DHCP
server does not give an IP address to the Server, the Server will use the
automatic private IP addressing IP: 169.254.0.0. ~ 169.254.255.255
 If you are not working in a DHCP network, you need to manually set the
Server’s IP address.
3.3.2 IP Address
Unless you are assigning an IP address using DHCP, you must obtain an unused IP
address from your network administrator.