User's Manual

Automatic shutdown function description
（1） When Bluetooth is connected, the system will automatically shut down
and goes into standby mode if the Bluetooth device does not play or
have no other signal for 20 minutes.
（2） After power-on, Bluetooth is not connected with other Bluetooth
devices, after 20 minutes, it will automatically shut down and goes into
standby mode.
The light of Indicator description
（1） The power indicator is on, wait to touch to be turned on.
（2） Turn on the Bluetooth mode, when the Bluetooth is not connected, the
indicator light blinks fast;
（3） The Bluetooth are connected and the indicator lights blinks slow;
（4） When AUX or AUDIO is connected, the indicator is always on.
（5） Standby mode Standby blinks once every 10 seconds.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.