INSTALLATION INSTRUCTIONS KBRF-300 RFI (EMI) FILTER – KB P/N 9484A Approved (EN55011) ! See Safety Warning on Page 1 TM A COMPLETE LINE OF MOTOR DRIVES © 2002 KB Electronics, Inc.
ii. ! SAFETY WARNING! Please read carefully This product should be installed and serviced by a qualified technician, electrician, or electrical maintenance person familiar with its operation and the hazards involved.
This product complies with all CE directives pertinent at the time of manufacture. Contact the Sales Department for detailed installation and Declaration of Conformity. I. II. APPLICATION NOTE This product is intended to be used with electronic motor speed controls containing the “CE” mark and manufactured by KB Electronics, Inc., Coral Springs, FL 33065 USA.
FIGURE 1 – MECHANICAL SPECIFICATIONS – INCHES / [mm] 2.30 [58.4] 5.30 [134.6] 1.38 [35.0] 1.78 [45.3] 1.31 [33.3] 0.75 [19.1] 6.00 [152.4] 6.40 [162.
FIGURE 2 – WIRING DIAGRAM 5
III. MOUNTING Mount the KBRF-300 on a flat surface using the two (2) mounting tabs. (See figure 1, on page 4.) Be sure unit is not exposed to environmental conditions which will adversely affect its operation such as water, excessive temperature or metal chips. IV. WIRING (See figure 2 on page 5) a) Wire KBRF-300 Filter to control using 1/4” - QD terminals. Wires should be as short as possible and may have to be shielded with the shield grounded (earthed) at both ends.
b) It is the responsibility of the system integrator to provide a finished machine that will conform to all RFI/EMI requirements. Installing the control in the way shown above, along with other CE approved guidelines, the control should not emit undesirable levels of RFI/EMI. These instructions do not guarantee that your system will meet all requirements for council Directive 89/336/EEC relating to EMC. A Declaration of Conformity is available upon request.
VI. LIMITED WARRANTY For a period of 18 months from the date of original purchase, KB Electronics, Inc. will repair or replace, without charge, devices which our examination proves to be defective in material or workmanship. This warranty is valid if the unit has not been tampered with by unauthorized persons, misused, abused, or improperly installed and has been used in accordance with the instructions and/or ratings supplied.
