Manual

TABLE OF CONTENTS

Section Page

i. Safety Warning .........................................................3

ii. Simplified Operating Instructions ............................................3

I. General Information .....................................................3

II. Setting Speed or Torque Mode of Drive (Jumper J1) ............................6

III. Setting Selectable Jumpers ...............................................6

IV. Mounting ..............................................................7

V. Wiring ................................................................8

VI. Fusing ...............................................................10

VII. Operation ............................................................11

VIII. Trimpot Adjustments ....................................................11

IX. Function Indicator Lamps ................................................12

X. Optional Accessories ...................................................13

XI. Limited Warranty .......................................................20

TABLES

1. Electrical Ratings .......................................................4

2. General Performance Specifications .........................................4

3. Field Connections (Shunt Wound Motors Only) ................................8

4. Parts List ............................................................16

FIGURES

1. Control Layout .........................................................5

2a. Motor Speed vs. Potentiometer Rotation ......................................6

2b. Preset Motor Speed vs. Motor Load .........................................6

3a. Motor Output Torque vs. Potentiometer Rotation ...............................6

3b. Motor Speed vs. Applied Motor Load ........................................6

4a. Captive Screw Tightened In Case ...........................................8

4b. Captive Screw Engaged In Front Cover ......................................8

5. Connection Diagram .....................................................8

6a. Full Voltage Field .......................................................9

6b. Half Voltage Field .......................................................9

7. Tachometer Connection Diagram ...........................................9

8a. Remote Potentiometer Connection .........................................10

8b. Analog Voltage Connection ...............................................10

9. Remote Start/Stop Switch Connection ......................................10

10a. Inhibit Circuit Wiring ....................................................10

10b. Enable Circuit Wiring ...................................................10

11. Mechanical Specifications ................................................14

12. Schematic ............................................................15

13. Internal Connection Diagram ..............................................17

14. Connection Diagrams KBPC-225 With KBSI-240D (Signal Isolator) ................18